Side steps: These offerings combine the benefits of nerf bars and running boards by featuring large steps.Nerf bars: Nerf bars were originally designed for race cars, and they consist of stainless steel tubes with steps attached in shapes including oval, round, and rectangular.They are textured at the places where you step out of the doors of your vehicle with brackets, and they are usually made from heavy-duty stainless steel. Running boards: Traditional running boards consist of single bars that go down each side of the cab of your truck.While all of the offerings in this category are designed to provide a place to step as you get in and out of your truck or SUV, there are quite a few differences between the various models that are offered. What are the differences between running boards and nerf bars? To be certain that youll make the right decision, you should take a moment to review these simple answers to commonly asked customer questions. If youre looking for a way to make it easier to get in and out of your Silverado truck without compromising on style, then you should consider the new running boards and nerf bars in this category, many of which are available on eBay for various reasonable prices. When the installation is complete, make sure the bolts are properly tightened and the hardware is not loose.Nerf Bars & Running Boards for Chevrolet Silverado for Smooth Entries and Exits Proceed with the installation of the passenger side running board as you did on the driver’s side. If it does, the tank or tray will need to be dropped a bit (tank/tray removal is not required). When doing the installation at this side, make sure that the boards and mounting hardware does not interfere with the fuel tank or lower tank under the tray. Move to the passenger side of the Silverado truck. When done, attach it with bolts but do not overtighten the hardware (you can tighten it once the running board is leveled and adjusted). The running board has to be aligned 3 inches back from the wheel opening. Do not slide or rotate the running board to avoid damages. When brackets are installed, position the running board on the mounting brackets and and make sure it matches the bolts along it. Repeat these steps for the remaining 2 brackets on the drivers’ side. Snug but do not tighten the bolts for now. Mount brackets with bolts to the OE threaded holes. Keep in mind, that the brackets are universal and will work right both on the driver’s and passenger sides. The clip nut will go into the larger hole and the threaded nut has to be aligned with the smaller hole. Once the holes are located, remove the rubber plug from the larger hole. You need to install brackets by bolting them to the 1st, 2nd and 5th tabs. Inspect the rocker area of the truck and locate 5 tabs (pinch weld). Start the running board installation procedure from the driver’s side of your Silverado truck. It is enough to have the generic running board installation instruction handy to install running boards on your Silverado truck by yourself and save on the installation. Bully USA includes installation brackets and hardware with the running boards for your truck, unless the product description states that the hardware is not included. All details are noted in the installation sheet that is available along with every package. How to install running boards on Chevrolet Silverado: Step-by-Step Instructionĭetails and specs on the specific running boards installation depend on the exact year, model, cab type and trim level of the Silverado. Just consider your skills, time and budget to get the new running boards on your truck in the most convenient way.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |